Monitoring window layout
30
*1 When Temperature level display group view is set to On at Environment
setup in the Tool menu, an icon indicating the internal temperature of the
projector will be displayed on top of the projector icon. The default setting
is Off.
*2 Check the following items.
- Check that the projector's power is turned on.
- Check that the LAN cable is connected.
- Check that Standby Mode is set to Communication On (or Network On)
or Network Monitoring is set to On in the projector's configuration menu.
*3 Check that the projector has been correctly connected to the network.
*4 It describes DVI-D if the projector is equipped with both DVI-D and HDMI
input terminal.
*5 It describes HDMI if the projector is equipped with both DVI-D and HDMI
input terminal.
*6 Using Environment setup in the Tool menu, you can set a duration of time
after which the Replace Lamp notification will appear. (The notification will
appear earlier if the lamp needs to be replaced before the selected time.)
q
Detectable error information differs with the projector you are using.
Checking properties in detail
You can check the properties of Group and projectors in detail.
Lamp error (Lamp 2) Lamp failure at power on
(Lamp 1)
Lamp failure at power on
(Lamp 2)
High-temperature warning
Replace Air Filter No Air Filter
Low Air Flow Air Flow Sensor Err.
Supply System Error (Ballast
1)
Supply System Error (Ballast
2)
Cinema filter warning Shutter warning
Lamp Cover Open Lamp Error
Lamp Error (Lamp 1) Lamp Error (Lamp 2)
Lamp failure at power on Lamp failure at power on
(Lamp 1)
Lamp failure at power on
(Lamp 2)
High internal temperature
error
Low air flow error Air filter air flow sensor error
Internal Error Fan error
Sensor error Supply System Error
(Ballast)
Supply System Error (Ballast
1)
Supply System Error (Ballast
2)
Auto Iris Error Cinema filter error
Shutter error Cooling system error
(Peltier element)
Cooling system error
(pump)
Other error
To Next Page
Loading...
Need help?
General