Epson PowerLite 6110i - Page 17

Setting Up the Projector 17
Ideally, you should place the projector directly in front of the center of
the screen, facing it toward the screen squarely. The lens should be at
about the level of the bottom of the screen.
If you place the projector below screen level, you’ll have to tilt it up by
extending its feet. This causes the image to become “keystone” shaped,
but you can correct the distortion by pressing the or buttons
on the projector. See page 37 for detailed information about
correcting the image shape.
For instructions on installing the projector in a permanent location,
such as a classroom or conference room, see page 109.
note
After positioning the
projector, you may want to
connect a Kensington
MicroSaver
®
anti-theft
device to the lock port on the
projector’s left side. You can
purchase this from Epson;
see “Optional Accessories” on
page 14
.
You can also connect a
commercially available
anti-theft cable and lock to
the metal bar on the bottom
of the projector.
Screen
Projector