Setting Up the Projector 23
Connecting Using a BNC-to-VGA Cable
1. Locate a BNC-to-VGA video cable (one may be included with
your video equipment).
2. Connect the BNC end of the cable to your player and the VGA
end to the
Computer1 port on the projector.
3. If you want to play sound through the projector, see page 27 for
instructions on connecting an audio cable.
4. If you don’t need to make any other connections, see Chapter 2
or the Quick Setup sheet for instructions on turning on the
projector and adjusting the image.
5. Once the projector is turned on, enter the projector’s Signal menu
and make sure Computer1 is set to
Auto; see page 56.
To Next Page
Loading...
