Epson PowerLite 6110i - Changing the Pointer Shape; Operating Two or more Projectors with the Remote Control

Using the Remote Control 47
Changing the Pointer Shape
Follow the steps below to change the pointer shape.
1. Press the
Menu button on the remote control, highlight the
Settings menu, and press Enter.
You see this screen:
2. Highlight
Pointer Shape and press Enter.
3. Select the pointer you would like to use, then press
Enter to
select it.
4. When you have finished selecting a pointer shape, press the
Menu
button to exit the menu system.
Operating Two or More Projectors with
the Remote Control
If you’re using more than one projector, you can control all the
projectors—or just selected ones—by using the projector ID system.
To operate a projector, you have to set the remote control’s ID to
match that of the projector. Or you can control all the projectors at
once by setting the remote control’s ID to zero.