Using the Remote Control 49
3. While holding the ID button, press a numbered button on the
remote control (0 through 9) to select the desired ID. Select zero
to control all projectors, or select a number to match the ID of the
projector(s) you want to operate.
After setting the ID, you can check whether the remote control works
with a specific projector:
1. Point the remote control at the projector you want to check.
2. Press the
ID button on the remote control. You see a message on
the screen like one of these:
If the message says the remote control is “On,” then you can use
the remote control to operate that projector. If it says “Off,” then
you have to change the ID of the remote control and/or projector
before operation is possible.
To Next Page
Loading...
