Configuring the Projector 61
■ User’s Logo
Turn this setting On to display the image or logo you have
captured whenever the projector is turned on. See page
page 66 for more information.
■ Projection
Front:
Projector is in front of the screen.
Front/Ceiling: Projector is in front of the screen, mounted
upside-down from the ceiling.
Rear: Projector is behind the screen.
Rear/Ceiling: Projector is behind the screen, mounted
upside-down from the ceiling.
■ Operation
Direct Power On:
When this feature is enabled, projection
starts as soon as you plug in the power cord. You don’t have
to press the P
Power button.
Sleep Mode: When this feature is enabled, the projector’s
lamp automatically turns off when the projector has not
received any input signals for more than 30 minutes. This
conserves electricity, cools the projector, and extends the life
of the lamp. To resume projecting, press the P
Power
button.
Sleep Mode Timer: When the Sleep Mode setting is
enabled, you can set the period of time before the projector
turns off automatically, from 1 to 30 minutes.
High Altitude Mode: Turn this setting On when using the
projector above an altitude of 4,921 feet (1,500 meters). This
setting ensures that the internal temperature of the projector
is regulated properly. Turn this setting off for lower
elevations.
■ Standby Mode
Select Network On to use the network monitoring and
control functions while the projector is in standby mode (the
P Power light is orange).
note
When Direct Power On is
enabled, press the P
Power
button to turn the projector
off, wait until the P Power
light remains solid orange,
then unplug the projector.
To Next Page
Loading...
