Configuring the Projector 67
3. Use the pointer button to highlight User’s Logo, then press
the
Enter button.
4. When you see the message
Choose this image as the User’s
Logo?
, select Yes and press Enter. A selection box displays over
the image.
5. Use the pointer button on the remote control to select the
area of the image you want to use. Once you have selected the
area, press
Enter.
6. When you see the message
Select this image?, choose Yes and
press
Enter.
If you want to change the area selected, select
No, press Enter and
repeat steps 4 through 6.
note
If the User’s Logo Protect
function is enabled, you see
a message that the logo
cannot be recorded. You’ll
need to disable the User’s
Logo Protect function before
you can create or change the
User’s Logo. See page 70.
To Next Page
Loading...
