Epson PowerLite 8350 - Page 2

INSTALLATION
HANDBOOK
Remote Control Info
2
Epson PowerLite 8350 / 8700 UB
Installing Batteries in the Remote Control
The remote control uses two AA batteries.
WARNING: Keep batteries away from children. If a battery is swallowed, contact your doctor
immediately.
1. Release the tab and lift open the cover.
2. Insert two new AA batteries as shown.
3. Insert the tab on the cover and press it down until it
clicks into place.
Aim the remote control at the screen, or at the front or
back of the projector. Make sure you are within 30 feet
of the projector.
If you suspect the batteries are weak, press the illumination button. If the buttons do not
glow, replace the batteries.
Solving Remote Control Problems
The projector doesn’t respond to remote control commands.
Make sure you’re within about 30 feet of the projector, and the remote control is aimed at
the projector’s front or back sensor within the ranges shown below.
You may need to replace the remote control batteries (see page 21). Press the
illumination button and check if the buttons glow. If they don’t, replace the batteries.
Dim the room lights and turn off any fluorescent lights. Make sure the projector is not in
direct sunlight.
Turn off nearby equipment that emits infrared energy, such as a radiant room heater.
Make sure there are no objects between the remote control and the IR receiver.
Approx.60
Approx.60
Approx.60
Approx.60