Epson PowerLite 97 User Manual

INSTALLATION
HANDBOOK
Lamp and Status Information
Epson PowerLite 97 / 98 / 99W / 955W / 965
2
Power light Status light Lamp light Temp light Status and solution
Off Flashing blue Off Orange Projector has overheated and
turned off. Leave it turned off to
cool down. Once the Temp and
Status lights turn off and the power
light turns blue (after about five
minutes), try the suggestions
below:
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
• If operating the projector at high
altitude, turn on High Altitude
Mode.
• If the problem persists, unplug
the projector and contact Epson
for help.
Off Flashing blue Orange Off Lamp has a problem.
• Check to see if the lamp is
burned out, broken, or installed
incorrectly. Reseat or replace the
lamp as necessary.
• Clean or replace the air filter.
• If operating the projector at high
altitude, turn on High Altitude
Mode.
• If the problem persists, unplug
the projector and contact Epson
for help.
Flashing blue Light status Flashing Light status Replace the lamp soon to avoid
varies orange varies damage. Do not continue using the
projector.
Off Flashing blue Off Flashing A fan or sensor has a problem.
orange Turn the projector off, unplug it, and
contact Epson for help.
Off Flashing blue Flashing Off Internal projector error. Turn the
orange projector off, unplug it, and contact
Epson for help.
Off Flashing blue Flashing Flashing Auto iris error. Turn the projector
orange orange off, unplug it, and contact Epson for
help.
Off Flashing blue Orange Orange Power error. Turn the projector off,
unplug it, and contact Epson for
help.
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.

Epson PowerLite 97 Specifications

General

Matrix type	3-panel (p-Si TFT active)
Number of colors	1.073 billion colors
Native aspect ratio	4:3
Projection distance	0.9 - 9 m
Projection technology	3LCD
Contrast ratio (typical)	10000:1
Screen size compatibility	- \
Projector native resolution	XGA (1024x768)
Keystone correction, horizontal	30 °
Focus	Manual
Optical zoom	1.2 x
Zoom capability	Yes
Focal length range	16.9 - 20.28 mm
Aperture range (F-F)	1.58 - 1.72
Lamp type	UHE
Lamp power	200 W
Light source type	Lamp
Service life of light source	5000 h
Service life of light source (economic mode)	6000 h
3D	-
Full HD	No
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions	1280 x 960, 1280 x 1024 (SXGA), 1280 x 800 (WXGA), 1366 x 768, 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 1600 x 1200 (UXGA), 640 x 480 (VGA), 800 x 600 (SVGA)
Audio (L/R) in	3
USB connector type	USB Type-A, USB Type-B
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	37 dB
Noise level (economic mode)	28 dB
RMS rated power	16 W
Placement	Desktop, Ceiling
Product type	Standard throw projector
Product color	White
Cable lock slot type	Kensington
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	2.9 W
Power consumption (typical)	294 W
Power consumption (PowerSave)	245 W
Operating temperature (T-T)	5 - 35 °C
Sustainability certificates	RoHS
Cables included	VGA
Remote control type	IR

Weight and Dimensions

Depth	243 mm
Width	294 mm
Height	86 mm
Weight	2700 g