209
Setting Options Description
Source Signal Format
Overscan
EDID
Reset to Defaults
Displays settings selected for the current
input source
Signal Format: sets the signal type and
video range for certain input sources
• Video Signal: specifies the signal type
from input sources connected to video
ports; if interference appears or no image
appears when set to Auto , select the
appropriate signal type
• Video Range: sets the video range to
match the setting of an input source
connected to the HDMI ports
Overscan: changes the projected image
ratio to make the edges visible by a
selectable percentage or automatically
when projecting a component signal
EDID: describes the display capabilities of
your projector when the selected input
source is HDMI; change this setting as
necessary according to the resolution of the
current input source
Reset to Defaults: resets all settings for
the current input source
A/V Output While Projecting
Always On
Determines when the projector outputs
audio and images to external devices; set
to Always On to output audio and images
when the projector is in standby mode
Audio Output Auto
Audio1
Audio2
Audio L/R
Sets the audio input port when projecting
from input sources other than HDMI, LAN,
and Screen Mirroring
HDMI Audio Output HDMI1 Audio Output
HDMI2 Audio Output
Sets the audio input port when projecting
from one of the HDMI ports
To Next Page
Loading...
