193
Setting Options Description
Standby Mode Communication On
Communication Off
Port
Enable this setting to allow the
following operations to occur
when the projector is in standby
mode:
• Monitor and control the
projector over a network
• Output audio and video to an
external device (A/V Output
must be set to Always On)
• Communication from the
HDBaseT port (Control
Communications must be set
to On)
Port: selects the port to use from
Wired LAN or Wireless LAN
when Standby Mode is set to
Communication On
HDBaseT
(PowerLite
L510U/L610U/L610W/L615U)
Control Communications
Extron XTP
Selects the communication
settings for connections to an
HDBaseT transmitter or switcher
Control Communications:
enables or disables
communication from the Ethernet
and serial ports on the
transmitter; turning on this setting
disables the projector's LAN, RS-
232C, and Remote ports (Extron
XTP must be turned off to use
this setting)
Extron XTP: set to On when you
connect an Extron XTP
transmitter or switcher to the
HDBaseT port
To Next Page
Loading...
