Epson PowerLite Pro G5550 - Connecting to Video Equipment

36 Setting Up the Projector
Connecting to Video Equipment
You can connect several video sources to the projector at the same
time. Before starting, look at your video equipment to determine its
available video output connections:
■ If your video player has an HDMI connector, see “Connecting an
HDMI Video Source” on page 37.
■ If your video player has a DVI-D video port, see “Connecting a
DVI-D Video Source to the DVI-D Port
(G5450WUNL/G5750WUNL only)” on page 38 or
“Connecting a DVI-D Video Source to the HDMI Port” on
page 39.
■ If your video player has a component video port (three connectors
labeled either Y/Cb/Cr or Y/Pb/Pr), see “Connecting a
Component Video Source” on page 42.
■ If your video player has a yellow RCA video output connector, or
if you’re using a coax video cable, see “Connecting a Composite
Video Source” on page 40.
■ If your video player has an S-Video connector, see “Connecting
an S-Video Source” on page 41.
HDMI connector
BNC connector
(component or
composite video)
RCA connector
(composite video)
S-Video
connector