40 Setting Up the Projector
Connecting a Composite Video Source
1. If your video cable has an RCA connector, connect it to the
yellow video output connector on your player and the yellow
Video2 connector on the projector (as shown below). Or if you’re
using a coax video cable, connect it to the
Video1 connector on
the projector.
2. If you want to play sound through the projector, see page 46 for
instructions on connecting audio cables.
3. When you’ve finished making any connections, see page 51 for
instructions on turning on the projector and Chapter 2 for
instructions on displaying and adjusting the image.
note
If the video cable was not
rovided with your video
device, you can purchase one
rom an electronics dealer.
To Next Page
Loading...
