Epson PowerLite Pro G5550 - Removing the Wireless 802.11 G;B;A Module

Using the Projector on a Network 97
Removing the Wireless 802.11g/b/a
Module
Follow these steps to remove the module from your projector.
1. If you’re running EasyMP Network Projection, click
Disconnect
on the control bar.
2. Check the access light to make sure it isn’t flashing.
3. Turn off the projector and unplug it.
Click
Disconnect
caution
Never remove the module
while its access light is green
or when projecting
wirelessly. You may damage
the module.
Access light