2. Insert the end of the cable clip anchors into the cable clip slots near the power inlet and HDMI port.
1 Cable clip slot
2 Cable clip anchor
3 Cable clip
3. Place the open cable clips around the power and HDMI cables, but don't lock them into place.
4. Slide each cable clip onto the anchors and lock the clips onto the power and HDMI connectors as
shown.
To remove the cable clips, open the clips and disconnect the cables. Then pinch the sides of each cable
clip anchor and carefully pull them out of the cable clip slots.
Parent topic: Setting Up the Projector
Related tasks
Connecting to a Computer for HDMI Video and Audio
Connecting to an HDMI Video Source
Installing Batteries in the Remote Control
The remote control uses the two AA batteries that came with the projector.
53
To Next Page
Loading...
