Epson PowerLite Pro G6170 - Setting up Monitoring Using SNMP

Setting Up Monitoring Using SNMP
Network administrators can install SNMP (Simple Network Management Protocol) software on network
computers so they can monitor projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
1. Press the Menu button.
2. Select the Network menu and press Enter.
3. Select Network Configuration and press Enter.
4. Do one of the following:
• Select the Others menu and press Enter.
PowerLite Pro G6870/G6970WU
• Select the Administrator Setting menu and press Enter, then select the SNMP menu and press
Enter.
80