ESC/VP21 Commands
135
ESC/VP21 Commands
Serial Connection
• Connector shape: D-Sub 9-pin (male)
• Projector input port name: RS-232C
Communications Protocol
• Default baud rate setting: 9600 bps
• Data length: 8 bit
• Parity: None
• Stop-bit: 1 bit
• Flow control: None
Command List
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
<At the projector>
<At the computer>
<At the projector> (PC serial cable) <At the computer>
Signal
Name
Function
GND Signal wire ground
TD Transmit data
RD Receive data
To Next Page
Loading...
