Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless LAN Access Point
146
Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless LAN Access Point
There are two methods for setting WPSg.
• Push Button Method
SSID and security are set automatically when the [Enter] button is
pressed on the projector's control panel and the dedicated button on
the access point equipment. This method is recommended when the
projector and access point are close together.
• PIN Code Method
SSID and security are set automatically by inputting an 8-digit code
that was assigned to the projector from the computer to the access
point in advance. Make connection settings between the computer and
the access point in advance. For details on how to make this
connection, refer to the manual provided with the access point. This
method is recommended when the projector is mounted on the ceiling.
q
Refer to the documentation for the access point device and to the following
section when using any connection method other than WPS. s "Wireless
LAN Menu" p.74
Connection Setup Method
Procedure
A During projection, press the [Menu] button and select
"Network" - "Network Configuration" from the configuration
menu.
The Network Configuration screen is displayed.
To Next Page
Loading...
