Network Menu
87
SNMP menu
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.
Sub Menu Function
SNMP Set this parameter to On when using SNMP
g to monitor the projector.
Trap IP Address 1/Trap IP
Address 2
When SNMP is set to On, you can set up to two IP addresses as SNMP trap notification destinations.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Community Name Set the community name of SNMP. You can enter up to 32 single-byte alphanumeric characters.
To Next Page
Loading...
