33
Chapter 3 Setting
3
PP-50BD / PP-7050BD
EPSON Total Disc Setup Properties window is displayed. In the window, the following settings can be made.
Setting Item Explanation
Name You can change the name of PP-50BD / PP-7050BD. The name is used to
be specified in the JDF file using Publisher key.
Up to 64 characters can be used for the name.
You cannot register multiple PP-50BD / PP-7050BD with the same name.
Stacker
Settings
Publish Mode Select the publishing mode from the following two options;
PP-50BD
“Standard Mode”, and “Low-volume Mode”.
PP-7050BD
“Standard Mode”, “Low-volume Mode” and “Error Rate Measurement
Mode”
When the read back mode is selected in PP-50BD / PP-7050BD, a job
cannot be published from TD Bridge.
See the PP-50BD / PP-7050BD User’s Guide for more information on the
publishing mode.
Stacker 1,2 When “Standard Mode” is selected:
Select disc type for Stacker 1 that is used for blank discs. Stacker 2 is used
for ejected (published) discs.
When “Low-volume Mode” is selected:
Select disc type for both Stacker 1 and 2 that are used for blank discs.
When “Error Rate Measurement Mode” is selected:
Stacker 1 is used for the source.
Stacker 2 is used for ejected (published) discs.
Drive
Settings
Number of write retries Specify the number of retries in the case of writing errors. The number can
be entered in the range of 0 to 9.
Printer
Settings
Show error mark on
discs that experience
error
Tick the checkbox when you want to print an error mark on published
discs that may have been improperly burnt (an error occurs during
writing). This helps you to separate the failed discs from the normal ones.
To Next Page
Loading...
