186
You see a screen like this:
7. Select the Blending setting and select On.
8. Select the Blend Start Position setting and adjust the point where edge blending begins.
9. Select the Blend Range setting and use the arrow buttons to select the width of the blended area so
that the displayed guides are at the edges of the overlapping area between the two images.
10. Press Esc to go back to the previous screen.
11. Select the Blend Curve setting and select a gradient for the shaded area on the projectors.
12. When the edges are blended, turn off the Guide Display and Pattern Guide settings to check the
final settings.
13. When you are finished, press the Menu button.
Parent topic: Using Multiple Projectors
To Next Page
Loading...
