230
Setting Description
A/V Mute Settings Adjusts the A/V Mute settings
Fade-in: sets the number of seconds for a fade-in transition
effect when displaying an image
Fade-out: sets the number of seconds for a fade-out transition
effect when hiding an image
A/V Mute Timer: turns off the projector automatically if A/V
Mute is enabled and 2 hours of inactivity has passed
A/V Mute Release: select A/V Mute if you want to use only the
A/V Mute button to turn off A/V mute, or select Any Button to
use any button to turn it off
Advanced See the next table in this topic
Date & Time Adjusts the projector's time and date settings
Lens Calibration Displays information about the lens currently in use
Advanced settings
Setting Description
BNC Sync Termination Sets the termination for the signal from the BNC port (set to off
unless you need analog termination, such as for switchers)
Remote Control Type Select Normal to use the remote control that came with the
projector, or Simple to use a different Epson projector remote
control and disable the remote control that came with the
projector
Beep Controls the beep that sounds when you turn the projector on
or off
Indicators Select Off to turn off projector lights, except warning lights
Instant Off Select Enabled to place the projector in standby mode after
turning it off, or Disabled to place the projector in standby
mode approximately 75 seconds after turning it off
Inv Direction Button Enable this setting if you installed the projector on a ceiling and
want to invert the direction of the arrow buttons on the control
panel
To Next Page
Loading...
