105
Art-Net Channel Definitions
Art-Net is an Ethernet communication protocol based on the TCP/IP protocol. You can control the
projector by using a DMX controller or an application system.
The following table lists the channel definitions used to control the projector in Art-Net.
Begin by setting channel 13 to Can control.
Note: When controlling the projector using Art-Net and performing operations from the remote control or
control panel, settings made by the DMX controller or application software may not be applied to the
projector correctly or may differ from the projector's actual status. If you want to apply control for multiple
channels to the projector, set Channel 13 to Cannot control before you make any other settings. Then
set Channel 13 to Can control after setting multiple channels. You can then control the projector without
changing the setting for Channel 13.
Channel/Function Operation Parameters Description
1 Adjusting light
(dimming)
0% to 100% 0 to 255 Adjusts the image
brightness (default is
0)
2 Shutter control Shutter closed
Non-operational
Shutter open
0 to 63
64 to 191
192 to 255
Closes and opens
the shutter (default is
128)
3 Switch source Non-operational 0 to 7, 16 to 23, 40 to 47,
64 to 71, 88 to 255
Switches to the
specified source
(default is 0)
HDMI 8 to 15
HDBaseT 24 to 31
DVI-D 32 to 39
SDI 48 to 55
Computer 56 to 63
BNC 72 to 79
LAN 80 to 87
4 Lens position Non operational
Move to home position
0 to 31, 64 to 255
32 to 63
Shifts the lens to the
home position
(default is 0)
To Next Page
Loading...
