220
Note: To reset all saved memories of all types, select Reset All Memories in the Reset menu.
7. Press Menu or Esc to exit.
Parent topic: Adjusting Projector Features
Saving a Scheduled Event
You can select projector commands you want to perform and schedule them as an event.
You cannot schedule an event to occur at the following times:
• Five minutes before or after a Color Calibration event
• Five minutes before or 30 minutes after a Screen Matching event
Note: Light Source Calibration events do not start if the projector is used continuously for more than 24
hours, or regularly turned off by shutting off the power outlet. Set Light Source Calibration events to
occur only after 100 hours of projector usage.
Note: Make sure to perform Screen Matching after executing Light Source Calibration.
Note: When you have set Light Source Calibration or Screen Matching events and you want to apply this
schedule to other projectors with tiling settings, set Sync Schedule to On.
1. Press the Menu button.
2. Select the Extended menu and press Enter.
3. Select the Schedule Settings setting and press Enter.
You see a screen like this:
To Next Page
Loading...
