285
On/Standby
(power) light
Status
light
Laser
light
Temp light Filter
light
Status and solution
Flashing blue Varies Flashing
orange
Varies Varies An unsupported lens is attached.
Attach only a supported lens.
Flashing blue Varies Flashing
orange
Varies Varies Power warning. The power voltage
was not measured correctly, so the
brightness of the light source has
been dimmed. Contact Epson for
help.
Flashing blue Varies Flashing
orange
Flashing
orange
Varies Shutter warning. After the warning is
displayed, an error occurs and
projection stops. Turn off the
projector, unplug the power cord, and
contact Epson for help.
Flashing blue Varies Varies Varies Orange Low air flow through the air filter.
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
• If the problem persists, unplug the
projector and contact Epson for
help.
Varies Varies Flashing
orange
Varies Varies The Constant Brightness setting
has expired.
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
Related concepts
Air Filter and Vent Maintenance
Wired Network Projection
Wireless Network Projection
To Next Page
Loading...
