88
2. Select the Extended menu and press Enter.
3. Select the A/V Settings > A/V Output, select Always On, and press Enter.
4. Select Standby Mode, select Communication On, and press Enter.
5. Press the Menu button to exit the menu system.
6. Turn off the projector, connect it to a wired LAN, and turn on the power using the power switch.
7. Hold down the LAN button on the projector control panel for at least three seconds.
You see the static IP setting menu:
8. Press the Enter button on the projector control panel, press the down arrow button to select OFF as
the DHCP setting, and press Enter again.
To Next Page
Loading...
