144
Correcting Image Shape with Point Correction
You can use the projector's Point Correction feature to fine-tune the image shape using points on a grid.
This is useful for adjusting overlapping areas in multiple projected images that do not line up correctly.
Note: You can move the points on the grid between 0.5 to 32 pixels in any direction. Coordinates for
pixels that extend beyond the edge of the projected screen are displayed as negative numbers.
1. Turn on the projector and display an image.
2. Press the Geometry button on the projector control panel or remote control.
3. Select the Point Correction setting and press Enter.
Note: If you see a confirmation message, press Enter.
4. Select the Point Correction setting again and press Enter.
You see this screen:
5. Select the following settings:
• To set the number of vertical or horizontal grid lines, select the Points (Vert.) or Points (Horiz.)
setting and select a value.
To Next Page
Loading...
