248
Setting Options Description
A/V Settings A/V Output
Monitor Out
A/V Output: Select Always On
to output images to an external
device even when the projector is
in standby mode (the Standby
Mode setting must be set to
Communication On)
Monitor Out: Outputs the image
source to an external monitor
connected to the Monitor Out
port when the projector is in
standby mode.
Standby Mode Communication On
Communication Off
Enable this setting to allow the
following operations to occur
when the projector is in standby
mode:
• Monitor and control the
projector over a network
• Output video to an external
device (A/V Output must be
set to Always On)
• Communication from the
HDBaseT port (Control
Communications must be set
to On in the HDBaseT
settings)
• Set the IP address on the LCD
display
To Next Page
Loading...
