Epson R200 - Stylus Photo Color Inkjet Printer - Page 10

EPSON Stylus Photo R200/R210 Revision A
TROUBLESHOOTING Troubleshooting with LED/LCD Indications and Status Monitor 3 Message 10
Error before ink
replacement Cleaning
-- -- On
This error is detected when replacing the Ink
Cartridge, if the new cartridge is defective.
Ink Low Condition -- -- Blink
Note :
Printing operation can be performed until it becomes ink
end condition even after the error message is displayed on
STM3. However, the Head Cleaning operation may not be
performed due to the Ink Low condition.
This error is detected when the ink consumption
reaches about 90%.
(Note)
When the Ink Low Condition is detected, the
Maintenance LED will blink. The printer will
continue to keep this LED status even if a new
Ink Cartridge is installed in the Ink Cartridge
replacement position. However, this LED status
will be reset (LED off) when "Carriage Unit"
returns to the home position.
Table 1-3. LED Indication and STM3
Printer status
LED indication
STM3 message Condition for error detection
Power Paper Ink