Epson R200 - Stylus Photo Color Inkjet Printer - Page 22

EPSON Stylus Photo R200/R210 Revision A
TROUBLESHOOTING Unit Level Troubleshooting 22
Table 1-9. Check Points for CD/DVD Tray Error to Each Phenomenon
Occurrence Timing
Position of CR
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
When printing
CDR/DVDR
-
An error occurs even though "CDR
Tray" is set when printing CDR/DVDR.
CDR Tray
1. Check if the contact point of "CDR Tray" with "CDR
Tray Sensor" is not cracked.
1. Replace "CDR Tray" with a new one.
CDR Tray Sensor
1. Check if "CDR Tray Sensor" is connected to CN11 on
"Main Board".
2. Check if "CDR Tray Sensor" is not damaged.
3. Check if "CDR Tray Sensor Connector Cable" is not cut
off.
1. Connect "CDR Tray Sensor" to CN11 on
"Main Board".
2. Replace "CDR Tray Sensor" with a new one.
3. Replace "CDR Tray Sensor" with a new one.
Main Board
1. Check if any device on "Main Board" is not damaged. 1. Replace "Main Board" with a new one.
Contact point
CDR Tray Sensor