Epson R200 - Stylus Photo Color Inkjet Printer - 2.3.3 ASF Unit Removal

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 40
2.3.3 ASF Unit removal
o External View
Figure 2-6. ASF Unit removal
o Parts/Units which should be removed before removing "ASF Unit"
Paper Support Assy./Housing (left/right)/Housing (frame)
o Disassembly Procedure
1. Disconnect the PG sensor connector cable & the CDR tray sensor cable from
the connector (CN14/CN11) of the "Board, Main".
2. Remove the screws (x5) for securing "ASF Unit", and remove "ASF Unit" to
the backside of the printer.
3. Remove the screws (x3) for securing the PG sensor connector cable & the
CDR tray sensor cable to ASF frame, and release the cables.
4. Remove the ASF unit backward.
5. Open "Hopper" and then remove "Compression Spring, 2.51".
6. Bow slightly down "Paper Return Lever" and release the dowels (x2) on the
both sides in the order of , ., and remove "Paper Return Lever".
7. Remove the screws (x2) for securing "Support Plate, Frame, ASF".
8. Release the hooks (x2) for securing "Extension Spring, 0.45", and remove
"Roller, Retard Assy.".
CN11
CN14
Board, Main
C.B.S(P4) 3x6 (5-7kgf/cm)
2
1
Paper Return Lever
Acetate tape
C.B.S 3x6 (5-7kgf/cm)
Backside
C.B.P 3x8 (5-7kgf/cm)
Screw, ASF (4-5kgf/cm)
Screw, Frame, Main 3x6 (5-7kgf/cm)
C.B.P 3x6 (3-5kgf/cm)
Support Plate, Frame, ASF
Extension Spring 0.45
Roller, Retard Assy.
Torsion Spring 6.45
C.B.S 3x6 (5-7kgf/cm)
ASF Unit
C A U T I O N
When removing "Paper Return Lever", the spring washer will
detach and drop. Take care not to lose it.
1 2