Epson R200 - Stylus Photo Color Inkjet Printer - Page 47

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 47
o External View
Figure 2-14. "Holder, Shaft Assy." removal (2)
n "LD Roller" removal
1. Release the dowels (x2) for securing "Paper, Block".
2. Release the dowels (x2) for securing "Shaft, LD Roller". Then, remove
"Shaft, LD Roller" and "Clutch" together from "Holder, Shaft, LD Roller".
3. Remove "LD Roller" from "Shaft, LD Roller".
Paper, Block
Spur Gear, 36.8
Clutch
Extension Spring, 0.143
Shaft, LD Roller
Dowel
PE Sensor Board
Hook
Torsion Spring, 0.22
Lever Sensor, PE
Holder, Shaft, LD Roller
LD Roller
Dowel
Dowel
Dowel
C A U T I O N
Do not touch "LD Roller" with bare hands.
o When reinstalling "LD Roller",
n Make sure to match the direction ( Mark) indicated on
"Shaft, LD Roller" and the direction ( Mark) indicated on
the back side of "LD Roller".
Figure 2-15. Position of "Torsion Spring, 137.7"
mark on "Shaft, LD Roller"
mark on "LD Roller"