Epson R200 - Stylus Photo Color Inkjet Printer - Page 54

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 54
o External View (Cont.)
Figure 2-25. "CR Unit" removal (4)
n "PW Sensor Board" removal
1. Release the hooks (x3) which secure "Cap, PW Sensor". Then, remove "Cap,
PW Sensor".
2. Pull out "PW Sensor Board" from the slot of "Carriage Unit". Then, remove
"PW Sensor FFC" from the connector of "PW Sensor Board" and remove
"PW Sensor Board" and "PW Sensor FFC".
n "CSIC Board" removal
1. Remove "Torsion Spring, Lever, Cartridge" from the hook and the dowel of
"Guide, IC".
2. Remove the dowel of "Lever, Cartridge" from the slot on the right side of
""Guide, IC" by using the tweezers. Then, remove "Lever, Cartridge.
3. Remove the screws (x2) for securing "Guide, IC", then release the hook with
the tweezers. And remove "Guide, IC".
4. Release the hooks (x2) for securing "CSIC Board", then push up "CSIC
Board" from the slot located on the bottom of "Carriage Unit" with a flat-
blade screwdriver or alike. Finally, remove "CSIC Board".
Hooks
Cap, PW Sensor
PW Sensor Board
Connector
Torsion Spring, Lever, Cartridge
Dowel
Hook
Guide, IC
Lever, Cartridge
Slot and Dowel
C.B.P 2.5x8 (3-5kgf•cm)
Hook
CSIC Board
Hooks
Electric Pole
Slot
C A U T I O N
When removing "Cap, PW Sensor", "PW Sensor Board" will be
free. Therefore, take care not to damage "PW Sensor Board".
C A U T I O N
Do not damage the electric pole with the flat-blade screwdriver or
alike when removing "CSIC Board".