Epson R200 - Stylus Photo Color Inkjet Printer - Page 94

EPSON Stylus Photo R200/R210 Revision A
MAINTENANCE Overview 94
<Lubrication Point>
Inside surface of "Guide Plate,
CR"
<Lubrication Type>
G-26
<Lubrication Amount>
Home possition side: To edge of
‘Cover, Guide Plate, CR’.
Opposite side: To about 40mm
from edge.
<Remarks>
Use a syringe to apply it
<Lubrication Point>
"CR Guide Shaft" outside the
bearing of the Carriage
<Lubrication Type>
G-63
<Lubrication Amount>
120mg-160mg x 2 points
<Remarks>
1. Use a syringe to apply it
2. Apply grease while rotating
"CR Guide Shaft"
Guide Plate, CR
<Lubrication Point>
Holes inside the Carriage
<Lubrication Type>
G-63
<Lubrication Amount>
150mg-210mg x 2 points
<Remarks>
Use a syringe to apply it
<Lubrication Point>
1. Cam of "Shaft, LD Roller"
shown in the figure
2. Contact point between cam of
"Shaft, LD Roller" and "Paper
Back Lever"
<Lubrication Type>
1. G-46
2. G-46
<Lubrication Amount>
Adequate dose
<Remarks>
Use a flux dispenser to apply it
Shaft, LD Roller
1
2
1
1