EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Disassembly of the Printer Mechanism 109
4.5.14 Front Paper Guide Assy/APG Sensor Assy
Parts/Components need to be removed in advance
All exterior parts/components / All control boards / Middle Housing / Printer
Mechanism / CR Scale / APG Unit / Printhead / Ink System / ASF Unit / Upper Paper
Guide / CR Motor / EJ Frame Assy / PF Encoder / PF Scale / CR Unit
Removal procedure
Removing the Front Paper Guide Assy
1. Remove the screw and remove the Parallelism Bushing L.
• Screw : C.B.S. M3x8 (tightening torque: 6-8 kgf.cm)
Figure 4-156. Removing the Parallelism Bushing L
2. Disconnect the connector of the PE Sensor Cable on the rear side of the
printer.
3. Remove the screw that secures the Front Paper Guide Assy.
• Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
Figure 4-157. Removing the PE Sensor Cable
4. Pull out the EJ Ground Spring to the front side.
Figure 4-158. Removing the EJ Ground Spring
C A U T I O N
Do not touch the surface of the rubber roller of the EJ Roller Assy
and the coated part of the PF Roller Assy as it can adversely affect
the print quality.
C H E C K
P O I N T
Refer to the Orientation Definition below for the directions
indicated in the following procedures.
•“4.1.6 Orientation Definition (p.61)”
Parallelism Bushing L
Front Paper Guide Assy
PE Sensor Cable
Connector
Front Paper Guide Assy
Front Paper Guide Assy
EJ Ground Spring
To Next Page
Loading...
