Epson R260 - Stylus Photo Color Inkjet Printer - Front Cover; Right Housing; Left Housing; USB Housing

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Exterior Parts/Components 66
4.2.3 Front Cover
 Parts/Components need to be removed in advance: Nothing
 Removal procedure
1.
Open the Front Cover.
2. Raise the CDR Guide Lever to lower the Stacker.
3. While pushing , disengage the left and right positioning holes of the Front
Cover in that order, and remove the Front Cover.
Figure 4-15. Removing the Front Cover (1)
4.2.4 Right Housing / Left Housing / USB Housing
 Parts/Components need to be removed in advance: Nothing
 Removal procedure
 Removing Right/Left Housings
1. Remove the two screws.
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
Figure 4-16. Removing the Right/Left Housings (1)
2. Insert a metal straightedge into the slit (ventilating opening) on the Right
Housing and disengage the hook.
3. While pushing , disengage the two tabs, and slide the Right Housing
rearward to remove it. (Refer to Fig.4-18)
Figure 4-17. Removing the Right/Left Housings (2)
Stacker
Front Cover
Positioning Hole
(right)
Positioning Hole
(left)
CDR Guide Lever
[Rear side]
Left Housing
Right Housing
Removal Direction
Push
[Right side]
: Tab
: Hook