Epson SG-WRITERII - SG-8002;SG-8003 Unwritable Frequencies; Confirmation of Unwritable Frequencies; SG-8002;SG-8003 Write and Test; Write and Test Dialog

10 Rev.7.4
2) Unwritable Frequencies
“This frequency need to be confirmed by EPSON”.is displayed. Please consult seller. When click OK button, A “No
answer ...” error is displayed in red in the Message bar, and Writer button is write disabled . Writing is not possible while
this is displayed.
 This can change due to setting conditions (Package/Rank).
6-4. Write and Test
When this button is clicked, the Write and Test dialog appears, and Write & Test and Monitor become possible.
1) (Write & Test)
This button is for Write and Test (Function Test).
 Fcalc Displays written frequency (MHz) and acceptable deviance (ppm).
 Fout Displays calculated value for output frequency (MHz) and deviance (ppm) from Fcalc.
Less than 1 10
-6
is not displayed.
 Write enabled
 Write disabled
2) (Monitor)
This button is for monitoring SG8002/SG8003 after writing. (Write and Data Verification cannot be performed.) Test results
are displayed as  to the left of the function.
 Verify Data Function for comparing written data and data read by SG8002/SG8003
 Fout Function for comparing output frequency and acceptable deviation