Epson SG-WRITERII - Hardware Specifications; USB Connector Details; Socket Information; Socket Pin Layout and Operating Range

12 Rev.7.4
7. Hardware Specifications
1) USB Connector
A connector for connecting with a DOS/V USB port and USB cable (mini B).
2) Socket
This is a socket for installing the SG8xxx Products other than the SG8xxxx should not be installed. This could cause a
malfunction.
1) Lever is up Lever raises when the SG8xxx is ejected.
2) Lever is in parallel position Lever should be parallel when the SG8002/SG803 is writing, or being calibrated
* For SMD devices, please use the adapter socket
3)Socket Pin Layout
No Signal Name No Signal Name
1 OE 14 VDD
2 NC 13 NC
3 NC 12 NC
4 OE 11 VDD
5 OE 10 VDD
6 NC 9 NC
7 GND 8 FOUT
* Do not connect NC to anything
7) Operating Range
Min. Typ. Max. Unit Comment
DC-IN 4.75 5 5.25 V USB bus power
IDD 0.9 2.5 W
VDD 0 8 V
OE 0 13 V
Environmental
Temperature
10 25 40
C
*1
*1 Do not write to the product (SG8xxx) above the environmental temperature.
1
7
14
8
USB Connector