Epson SG-WRITERII - Error Message Reference; Error Message Table

13 Rev.7.4
8.Error Message
Table of Error Messages
Message Content Cause
Confirm connection
Check USB connection
SG-WRITERII is not connected USB cable is not connected
Check USB cable
SG-WRITERII is not connected USB cable is not connected
Version error
HW/Firm Version Error
Improper version Wrong Hardware & Software versions
DLL Version error Improper DLL version Wrong software version
No answer No calculation results or analysis Unwritable frequency
Current Error
Short Check error
Power is improperly flowing to
device. (“Check Direction!” is
displayed in message box.)
 Direction of devices is backward
 Device is defective
 SG-WRITERII is defective
Pin Error Pins are not making contact
 Device is defective
 Defective device connection
 Device is not SG8002/SG8003
Blank Error Device already written
 Device is defective
 Defective device connection
 Device is not SG8002/SG8003
Reference Error Quartz frequency is out of
appropriate range
 Packages are different
 Device is defective
 Defective device connection
 Device is not SG8002/SG8003
Device Error Device has other errors Same as above
Verify Error Inconsistent Write Data and Read
Data
 Device is defective
 Defective device connection
Fout Error Output frequency is outside of
designated Rank
 Trimming defect when writing
 Defective device connection
IDD Error Exceeds standard value for power
consumption
 Device is defective
 Calibration of current measuring section
necessary
OE Error OE function is defective
 Device is defective
 Defective device connection
 Calibration of current measuring section
necessary
Vrange Error VDD(min) / VDD(max) error
 Device is defective