Epson Stylus 1500 - Page 115

5. Press SPACE and ENTER to enter the adjustment mode. The printer prints out an adjustment
pattern, and the adjustment selection menu appears, as shown below.
6.
Loosen 2 (CBP (P2) 3 × 6) screws securing the CR cover to the carriage unit. (See page 3-17.)
7. Move the angle adjust lever to the back or front so that the vertical lines are aligned
continuously (to bring A within 0 ± 0.02 mm), as shown in the following flowchart.
8. Press ENTER to exit the setting mode, or press SPACE to continue entering settings.
9.
Fasten the 2 (CBP (P2) 3 × 6) screws.
Figure 4-6. Black Head Angle Adjustment Pattern
A
START
Choose "Black Head Adj. " to enter
the black head angle adjustment.
Print the adjustment
pattern.
Is head angle OK ?
To main menu
What is the slant
of the angle?
Move the lever
1 step forward.
Move the lever
1 step backward.
Push the CR cover (H carriage holder) toward
the back once to eliminate looseness between
the black head and carriage unit.
Is head angle OK ?
Press SPACE key
Press ENTER key.
NO
YES
NO
YES
Figure 4-7. Black Head Angle Adjustment Flowchart
Adjustments
4-12 EPSON Stylus 1500 Service Manual