8. Lower the output tray to the printing position. Make sure
that the rear edge guide of the paper tray is positioned
under the output tray. The rear edge guide must be under
the output tray to allow room for the paper loaded in the
sheet feeder and to prevent a paper jam.
Testing the Printer
Before continuing, test the printer to ensure it is functioning
properly. For the self test, use paper that is at least 8.25 inches
(210 mm) wide. If you load smaller paper, the print head will
spray ink directly onto the platen, which could mar future
printouts.
1. Press the
Operate
button to turn off the printer.
c
Caution:
Never turn off the printer by unplugging it or turning off
a power strip. Always turn off the printer by pressing the
Operate
button.
2. While holding down the
Load/Eject
button, press the
Operate
button to turn on the printer. Wait for the paper
to load, then release the buttons.
Setting Up the Printer
1-21
To Next Page
Loading...
