199
199
If you want to print multiple images on roll paper and have the printouts
rolled up automatically, you can use the optional Auto Take-Up Reel
(Epson Stylus Pro 9890 only).
To install the Auto Take-Up Reel, follow the instructions in the manual that
came with it.
You can wind your printed media either forward (with the printed surface
outside), or backward (with the printed surface inside).
The table below describes the status of the Auto Take-Up Reel as indicated
by the
Sensor light.
Sensor light status Description
On Ready to use.
Flashing rapidly Operating
Flashing slowly Power-saving mode
Flashing very slowly The Auto Take-Up Reel has an error and stopped
working; check the installation and see page 187 for
additional solutions.
Off Turned off.
Appendix B:
Using the
Optional Auto
Take-Up Reel
Note: Epson
Doubleweight or
Singleweight Matte paper
should be wound forward.
Winding forward
Winding backward
Sensor
light
To Next Page
Loading...
