Epson Stylus CX3700 - 4.3 Disassembly Procedures

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedures 96
4.3 Disassembly Procedures
The flowchart below shows step-by-step disassembly procedures. When disassembling each unit, refer to the page number shown in the figure.
Figure 4-1. Disassembling Flowchart
 To remove the “Ink System Unit”, all parts shown in the red boxes need to be removed.
 To remove the “Paper Guide Front Unit”, all parts shown in the red boxes need to be removed.
START
“4.4.1 Document Cover/Document Cover
Mat/ASF Cover” (p97)
“4.4.5 Panel Unit” (p100)
“4.4.6 Housing, Upper” (p101)
“4.4.8 Printer Mechanism” (p104)
“4.4.11 Main Board Unit” (p111)
“4.4.16 CR Guide Frame” (p118)
“4.4.17 CR Motor” (p119)
“4.4.19 Carriage Unit/CR Encoder Board/PW
Sensor Board/Head FFC” (p121)
“4.4.21 EJ Frame Unit” (p125)
“4.4.23 Paper Guide Front Unit” (p127)
“4.4.24 PF Roller Unit” (p128)
“4.4.12 ASF Unit” (p113)
“4.4.13 Holder Shaft Unit” (p115)
“4.4.22 Ink System Unit” (p126)
“4.4.2 Paper Support Assy.” (p98)
“4.4.4 Scanner Unit” (p99)
“4.4.7 Printhead” (p102)
“4.4.9 PS Board Unit” (p107)
“4.4.18 PF Motor” (p120)
“4.5.1 Scanner Housing, Upper” (p129)
“4.5.2 Scanner Carriage Unit” (p130)
“4.4.3 Stacker Assy.” (p98)
“4.5.3 Scanner Motor Unit/Scanner HP
Sensor/ Driven Pulley” (p132)
“4.4.10 Waste Ink Pads/Stacker Lock/
Rubber Feet” (p108)
“4.4.20 Paper Guide Upper Unit” (p124)