Setting Up Your Printer
27
Tasmania
shortset.bk Rev. C
A5 size SETUP.FM
10/7/99 Pass 2
R
Proof Sign-off:
K. Nishi _______
N.Nomoto _______
J.Hoadley _______
1. Lower the output tray and slide out the extension. Next, slide
the left edge guide so that the distance between the edge
guides is slightly wider than the width of your paper.
2. Fan a stack of paper; then tap it on a flat surface to even the
edges.
3. Load the stack of paper with the printable side up and the
right edge of the paper resting against the right side of the
sheet feeder. Then slide the left edge guide against the edge
of the paper.
Note:
❏
Always load paper into the sheet feeder short edge first.
output tray
edge guide
printable
side up
To Next Page
Loading...
