#"$
Your printer switches to the modem port or won’t confirm on the printer
port (Macintosh)
You’re using
background printing
on a Macintosh.
You need to increase the memory allocated for your application, EPSON
Monitor3, or both. Choose Get Info from the File menu when the
application is active or when EPSON Monitor3 is selected and increase
the memory allocation. See Using Monitor3
for more information.
If that doesn’t work, turn off background printing in the Chooser or in
your printer software; see Using Background Printing on the Macintosh
for instructions. (You won’t be able to use Monitor3.)
You’re not using ECP
or Enhanced mode
and/or DMA transfers.
If your computer supports ECP or Enhanced mode and/or DMA
transfers, turn them on to speed up printing. See your computer
documentation for details.
Possible cause Solution
Your Macintosh has
extension conflicts.
Make sure AppleTalk
®
is inactive. In the Chooser, select any Apple serial
printer (such as the LaserWriter) and choose the printer port. Close the
Chooser, then reopen it and select the SP 1200 icon and the printer port.
Then restart your system.
You’re using an
AppleTalk cable.
Make sure you’re using a LaserWriter II serial cable. See Macintosh
System Requirements for more information.
Possible cause Solution
To Next Page
Loading...
