2013/Feb/08
Revision: 1 Page: 41
In run-length encoding compression mode, the data to be printed is always
transferred in the format (counter) + (data), where counter represents one byte of
information.
If 0 counter 127, then the data following the counter is non-compressed data, and the
length of the compressed data is (counter)+1 bytes.
If 128 counter 255, then the data following the counter will be one byte of
compressed data, . This single compressed byte of data is thereafter to be repeated
257-(counter) times..
3) This function also increments the X printing position relative to the current X printing
position by the amount: (256 x nH + nL) x h/3600 x 25.4mm.
If this command specifies an X position in the non-printable area (right margin), the right
margin position is automatically reset to the X value of the new printing position.
4) If image data is designated for a non-printable area, then the image data designated for that
area is ignored.
The following parameter combinations are supported by this command:
This printer doesn’t have printer microweave mode.
1. Case of microweave mode off
Mode Parameter ESC(e*3 Used Nozzle number Comment
(V x H) c v h m n2
360x360 0/1/2 10 10 1/8/24 00h 90Nozzles *1 *2
*1 In these circumstances, it is recommended to set m equal to 1.
*2 Whenever the ESC . command is used, the Normal (ESC ( e 2 0 0 0)) size must be selected.
[Initial State] Character mode
[Related Commands]
[Setting] Commands whose settings are affected by this command.
None
[Setting] Commands that change the effects of this command.
None
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
None
To Next Page
Loading...
