2013/Feb/08
Revision: 1 Page: 43
5.1.17. Set the raster image resolution ESC (D nL nH rL rH v h
ESC (D nL nH rL rH v h Ver 1.00
[Name] Set the raster image resolution
[Format] 1BH, 28H, 44H, nL, nH, rL, rH, v,h
[Range of Definition]
nL=04H, nH=00H
0 <= v <= 127
0 <= h <=127
[Function]
1) Sets the raster image resolution ( ESC i ).
Vertical resolution : ( rH*256 + rL ) / v dpi
Horizontal resolution : ( rH*256 + rL ) / h dpi
2) Available resolutions are : 120, 180, 360, 720dpi
3) Following parameters are supported.
This printer doesnāt have printer microweave mode.
1. Case of microweave mode off
Mode ESC ( D ESC i ESC(e Used Nozzle number Comment
(V x H) v / r h / r mH*256+mL n2
360x90 4/1440 16/1440 90 10h/33h/34h 90Nozzles
720x90 2/1440 16/1440 90 21h/25h 90Nozzles
*1 The parameter (mH*256+mL)=1 is recommended.
*2 This command may be especially useful in circumstances where programmers utilize their own chosen
algorithms to improve print quality.
[Initial State] -
[Related Commands]
[Setting] Commands whose settings are affected by this command.
The Resolution set of Raster image exerts the influence on the processing by the ESC i
command .
[Setting] Commands that change the effects of this command.
The Resolution setting of Raster image is returned to the initial states by the ESC @
and the ESC (G commands.
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
None
To Next Page
Loading...
