2013/Feb/08
Revision: 1 Page: 62
6.1.11. Set mechanism sequence "SN" 01H 00H 00H
[Format]
"SN" 01H 00H 00H
[Parameters]
None
[Function]
* Changes the mechanical sequence from the default environment to the values specified
by the below command. If the below command is not sent, the printer selects the plain
paper mechanical sequence.
Item Command
Paper path PP command
Duplex Printing DP command
Color / Monochrome setting ESC (K command
Set Print method ID ESC (m command
Paper types MI command
Platen gap setting US command
Bottom margin setting US command
Check paper size US command
* This command is only valid in remote mode.
To Next Page
Loading...
