Epson Stylus Photo 2100 - Page 128

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 128
3. Disengage the two Tie Wrap Bands and the hooks of the two Ferrite Cores secured
to the Board Unit to release the Connector Cables and FFCs.
Figure 4-15. Disconnecting the Connector Cables and FFCs
4. Disconnect the Connector Cables and FFCs from the Main Board, and pull and
remove the Board Unit from the Printer Mechanism again to the front as viewed
from the printer rear.
C A U T I O N
Do not cut the Convexes that secure the Ferrite Cores to the Board
Unit.
Refer to Figure 4-15, "Disconnecting the Connector Cables and
FFCs".
Tie Wrap Bands
Bottom rear side
Convexes
" Connect the Connector Cables to the Connectors that match in
colors and pin counts.
" For the two wide FFCs, connect the one on the printer rear side
to CN10 and the one on the front side to CN11. Refer to Figure
4-16, "Connection Destinations of Harnesses and FFCs".
Figure 4-16. Connection Destinations of Harnesses and FFCs
"
When reinstalling the Board Unit, fit the screws in the order
shown in Figure 4-14.
" When reinstalling the Board Unit, always bundle the Connector
Cables and FFCs (narrow FFCs) with the Tie Wrap Bands and
Ferrite Cores.
Refer to Figure 4-15, "Disconnecting the Connector Cables and
FFCs".
CN10 CN11
Printer
rear
Printer
front