Epson Stylus Photo 2100 - Page 148

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 148
.
C A U T I O N
" When reinstalling the Printhead, fully take care not to bring the
Nozzle surface into contact with the Carriage Unit.
Refer to Figure 4-62, "Removing the Printhead".
" After removing the Printhead (when not changing it), place it so
that the Head surface does not make contact with the desktop.
Refer to Figure 4-62, "Removing the Printhead".
" Refer to Figure 4-63 for the way to route the Head FFC Guides.
" When reinstalling the Head FFC Guides, fully be careful not to
bend or damage the FFCs. (Especially the two places in the right
photo in Figure 4-63.)
" Place the Head FFCs in the return portion on the right and rear
sides of the Carriage.
Refer to the right photo in Figure 4-63, "Routing the Head FFC
Guides".
Figure 4-63. Routing the Head FFC Guides
Portions to be noted
Carriage Unit top
A D J U S T M E N T
R E Q U I R E D
After removing or changing the Printhead, adjustments are
necessary.
Always make adjustments in the following order.
" When the Printhead was removed
1. Head cleaning
2. Head angular adjustment
3. Bi-D adjustment
4. Pixel Shift Adjustment
" When the Printhead was changed
1. Ink charge
2. Head ID input
3. Head angular adjustment
4. Bi-D adjustment
5. Pixel Shift Adjustment
6. PG adjustment
Refer to "Chapter 5 Adjustment" for the adjustment procedures.